對,不過這是1212M的manual裡的一段話:
"Important Information for Audigy, Audigy 2 and Audigy 2 ZS Owners
IF YOU OWN OR HAVE OWNED AN AUDIGY SERIES SOUND CARD READ THIS NOW!
After installing the E-MU 1010 PCI card, the Windows device manager may IMMEDIATELY attempt to install older Creative drivers.
It is CRITICAL that you CANCEL the operation when one of following dialogs appear:
For Windows XP - A Found New Hardware Wizard dialog will appear.For Windows 2000 - A Microsoft Digital Signature warning dialog will appear.
Once you have cancelled this operation, you may safely install the E-MU Digital Audio System Software using the Software/Driver Installation CD-ROM.
Note: If you follow this procedure, it is not necessary for you to uninstall the older Creative driver. Both products should now function properly. If you mistakenly fail to click CANCEL and the older Creative driver is installed, please contact E-MU Consumer Support for assistance."
表示1212M的PCI_id跟Audigy相同,才會造成driver誤認。
"有可能"1212M用的是修改過的emu10k2,姑且稱之為emu10k3好了。如果拿得到它的block diagram的話,要kX project driver支援它應該也不是一件難事,不過這應該也是很久以後的事了。
目前E-MU的driver的最大問題是sample rate大於48kHz時,不能使用DirectSound或是MME,只能用ASIO。